Soil Samples
Soil samples are performed by auguring down and retrieving the
sample from under or next to the underground storage tank. The soil samples are then delivered to an independent fully
accredited analytical testing laboratory that will provide a written report on the results.
Sample Gear only leaves small boring
In-place Tank DecommissioningThe tank is pumped out, cut open, thoroughly cleaned out and the tank is filled with sand or pea-gravel. The fill and vent pipes are removed and a letter is issued to the property owner upon completion.
\
Tanks washed clean
Certified Tank DecommissioningSoil Samples are taken from each end of tank 1-2 feet below bottom of tank. The tank is pumped out, cut open, thoroughly cleaned out and the tank is filled with sand or pea-gravel. The fill and vent pipes are removed. A certificate and report are issued to the owner and filed with the state DEQ (Oregon only).
Showing shiny clean metal
Certified Generic Remedy Clean-up
(<10,000ppm)Soil Samples are taken from around the tank to delineate the horizontal and vertical extent of contamination. Samples are analyzed to confirm that they all fall within the Generic remedy criteria. Tank is Decommissioned in place or by removal. A Generic Remedy report is written, certificate issued and filed with Oregon DEQ and property owner.
Tank filled with pea-gravel
Certified Risk Based Clean-up
(>10,000ppm)Soil Samples are taken from around the tank to delineate the horizontal and vertical extent of contamination. Site is evaluated for any health and safety concerns that are present due to contamination. Lab data is compared with health and safety standards and contamination plume is estimated. Tank is Decommissioned in place or by removal. A Risk Based report is written, certificate issued and filed with Oregon DEQ and property owner.
\
In-place Decommissioning completed
Underground Tank RemovalThe tank is pumped out, excavated, removed and soil samples taken. The tank is then transported to an approved site to have it cut, cleaned and scrapped. The hole is back filled and compacted. The ground cover and or sod are replaced at the excavation site. A Decommissioning Certification is issued to the property owner upon completion.
Tank removal project
Tank Installation/Replacement
(Underground or Above Ground Tanks)The tank is pumped out and any usable fuel is reclaimed and any waste product will be disposed. The tank is then transported to an approved site to have it cut, cleaned and scrapped. A new underground tank is installed in its place or a new above ground tank is installed. The hole is back filled and compressed. The ground cover and or sod are replaced at the excavation site.
Above ground Tank installed
Above Ground Tank RemovalThe tank is pumped out, and removed. The tank is then transported to an approved site to have it cut, cleaned and scrapped.
Site Remediation
Site RemediationIf petroleum contamination is discovered, cleanup of the petroleum contamination may be needed, depending on the severity. It involves the removal of the contaminated soil and disposed at a landfill and replaced with clean soil. We are able to assist you with possible insurance coverage for the cost of cleanups including Homeowners Insurance and State of Washington Pollution Liability Insurance Agency.
Petroleum contaminated soils
Environmental Site Assessment (Level
1)
An evaluation of commercial real estate environmental issues
past and present to satisfy the innocent land owner defense. Property is assessed for a range of contaminants within the
scope of CERCLA and petroleum products. All appropriate inquiry into the previous ownership and uses of the property
along with a site visit is conducted. A full detailed report is written according to ASTM Standard E 1527-00.
 |
||
 |
||
|
Mailing address: 10350 N. Vancouver
Way, #313, |
 |
Phone numbers PDX east (503) 252-0686 |
Email : info@advancedenvirotech.com